Control of the pore size distribution and its spatial homogeneity in particulate activated carbon
Por favor, use este identificador para citar o enlazar este ítem:
http://hdl.handle.net/10045/40803
Título: | Control of the pore size distribution and its spatial homogeneity in particulate activated carbon |
---|---|
Autor/es: | Hu, Cheng | Sedghi, Saeid | Madani, S. Hadi | Silvestre Albero, Ana | Sakamoto, Hirotoshi | Kwong, Philip | Pendleton, Phillip | Smernik, Ronald J. | Rodríguez Reinoso, Francisco | Kaneko, Katsumi | Biggs, Mark J. |
Grupo/s de investigación o GITE: | Materiales Avanzados |
Centro, Departamento o Servicio: | Universidad de Alicante. Departamento de Química Inorgánica | Universidad de Alicante. Instituto Universitario de Materiales |
Palabras clave: | Pore size distribution | Spatial homogeneity | Activated carbon |
Área/s de conocimiento: | Química Inorgánica |
Fecha de publicación: | nov-2014 |
Editor: | Elsevier |
Cita bibliográfica: | Carbon. 2014, 78: 113-120. doi:10.1016/j.carbon.2014.06.054 |
Resumen: | There are circumstances where it is desirable to achieve a particular, optimal, pore size distribution (PSD) in a carbon, including in the molecular sieving, gas storage, CO2-capture and electrochemical energy storage. Activation protocols that cycle a carbon a number of times between a low-temperature oxygen chemisorption process and a higher temperature pyrolysis process have been proposed as a means of yielding such desired PSDs. However, it is shown here that for PFA-based char particles of ∼100 μm in size, only the super-micropores are substantially developed under such an activation protocol, with the ultra-micropores being substantially un-touched. It is also shown that a typical CO2-activation process yields similar control over PSD development. As this process is nearly 15 times faster than the cyclic-O2 protocol and yields larger pore volumes and areas for a given level of conversion, it is to be preferred unless spatial homogeneous porosity within the particles is also desired. If such homogeneity is desired, it is shown here that CO2 activation should continue to be used but at a rate of around one-tenth the typical; this slow rate also has the advantage of producing pore volumes and areas substantially greater than those obtained using the other activation protocols. |
Patrocinador/es: | CH acknowledges a joint scholarship provided by China Scholarship Council (CSC) and the University of Adelaide. SS acknowledges the award of International Postgraduate Research Scholarship (IPRS) from the University of Adelaide. SHM acknowledges the award of a President’s Scholarship from the University of South Australia. The support of the Australian Research Council Discovery Program (DP110101293) is also gratefully acknowledged. |
URI: | http://hdl.handle.net/10045/40803 |
ISSN: | 0008-6223 (Print) | 1873-3891 (Online) |
DOI: | 10.1016/j.carbon.2014.06.054 |
Idioma: | eng |
Tipo: | info:eu-repo/semantics/article |
Revisión científica: | si |
Versión del editor: | http://dx.doi.org/10.1016/j.carbon.2014.06.054 |
Aparece en las colecciones: | INV - LMA - Artículos de Revistas |
Archivos en este ítem:
Archivo | Descripción | Tamaño | Formato | |
---|---|---|---|---|
2014_Hu_etal_Carbon_final.pdf | Versión final (acceso restringido) | 1,31 MB | Adobe PDF | Abrir Solicitar una copia |
2014_Hu_etal_Carbon.pdf | Accepted Manuscript (acceso abierto) | 2,99 MB | Adobe PDF | Abrir Vista previa |
Todos los documentos en RUA están protegidos por derechos de autor. Algunos derechos reservados.